Hi ALL,

This has been approved by Jane at syncrolight to sell some of my 8 channel DC controllers, to start i will be selling 5 at £25 each. Any info needed message me 

thanks 

steve

hi all, does anyone know an easy, effective way to create a graphic equaliser effect? i am looking to set up 5x 1 mtr 32 LED strips for this effect but not sure how best to do it.

thanks

Hi all just got a Signal Amplifier and manual shows a SPI Controller bit lost ?  

Well after Craig sorted me out a couple of weeks ago, i thought i was now on a winner so today the weather not being to bad and the garage not freezing i thought i would try the whole set up lights n all, after plugging in dozens of lights and setting everything up i clicked the device manager to set up the controllers, all controllers were flashing at start up and on plugging in the computer lead they all became steady, see the short video below.










all ok, but when i looked into the device manager there was not one controller showing, all channels were empty no matter what i clicked or tried, obviously on search it found no channels, see pics below.












So can anyone throw any light and help me with this problem.

Could anyone tell me how, or if, a DC08 and an ETH-08 be run at the same time in a single show?

I have tried everything that i can think of to no avail!

As a complete novice at this, i would appreciate any and all help!

Thank you in anticipation

Newbie here so go steady, I understand its probably the wrong time of the year to be asking for help, perhaps the admin can throw some light on my problem but after a couple of days scratching my head and trying to work stuff out, i have given up and i need help. I have been purchasing some controllers and lights and have more on order, but i thought i would try and set up a small show to see how things work out, as per instructions i went into device manager and added the four controllers I have, after numerous attempts i finally got the program to recognise my controllers.

Sorry about the long thread but wanted to try and explain as best i could with a few pics and a video, thanks for any help you can give.

[img][/img]

I then went into show player and set up a show with four shows.

[img][/img]



[img][/img]



No problems there i thought, then when the time came up that i set, nothing happened, the show player looks like it was playing, all lights were steady and the computer usb was flashing like it was doing something.


[img][/img]

hi guys,
can anyone tell me if it possible to start a show from an external switch or sensor as i want my shows to start when people come near and want to use PIR switches to activate my shows. This way i won't annoy the neighbours beyond the normal.

Hello everyone, this is my first post, so please excuse my lack of knowledge.

Could anyone tell me if it is possible to cut a segment from one display sequence and paste into another?
This would save me a huge amount of time and effort of it is possible to do this

Long story short I want to go all out pixels this year.

So syncrolight..........what’s planned this year for the pixels controller and software?

Will my ws2811 pixels have better compatibility too? I know through testing it’s the controller holding them back.

Thanks

Dan

Thank you to the team as Syncrolight, I have wanted a synchronised light show for years.
After many problems, I made a start this year.
Thanks for the advice over the phone also help from some on the forum.
Learning the electronics was much easier than the programming, but you have to start somewhere.

I used the free show builder shows, bought some on the website and then progressed to programming my own.

its not easy but as a complete novice I think I have made a start.
even had a small crowd watching my New year light show   


Heres a link to my new year show
New Year Lights