01-11-2020, 03:02 PM
I have just started trying out a few sequences with my new ethernet controller and 2 strings of ws2811 5v pixels (50 pixels).
In device manager they are all working fine and can be controlled individually.
However when in show designer and i select all 50 on, the last one in the string does not come on. If i put both strings together the 100th does not come on but all other 99 do.
I'm using a 10amp psu for the controller and lights, this happens both when powering both strings from the controller output and when I inject power to the second string.
Any suggestions where I'm going wrong?
In device manager they are all working fine and can be controlled individually.
However when in show designer and i select all 50 on, the last one in the string does not come on. If i put both strings together the 100th does not come on but all other 99 do.
I'm using a 10amp psu for the controller and lights, this happens both when powering both strings from the controller output and when I inject power to the second string.
Any suggestions where I'm going wrong?