28-11-2018, 02:21 PM
All our controllers primarily use our own protocol not DMX.
The software does however have a DMX interface that can be used.
Simply create a network of type DMX on the required USB/Serial device. Be sure to select a baud rate of 250000. (Proffessional licence required)
When using the software for a DMX network, the Controller ID is used to indicates the DMX address (The Channel ID is not used for DMX).
The software does however have a DMX interface that can be used.
Simply create a network of type DMX on the required USB/Serial device. Be sure to select a baud rate of 250000. (Proffessional licence required)
When using the software for a DMX network, the Controller ID is used to indicates the DMX address (The Channel ID is not used for DMX).