Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
something wrong again.
#1
Well after Craig sorted me out a couple of weeks ago, i thought i was now on a winner so today the weather not being to bad and the garage not freezing i thought i would try the whole set up lights n all, after plugging in dozens of lights and setting everything up i clicked the device manager to set up the controllers, all controllers were flashing at start up and on plugging in the computer lead they all became steady, see the short video below.










all ok, but when i looked into the device manager there was not one controller showing, all channels were empty no matter what i clicked or tried, obviously on search it found no channels, see pics below.




[Image: 2d6vepy.jpg]



[Image: 111pm2r.jpg]



So can anyone throw any light and help me with this problem.
Reply
#2
First double check your rs485 network wiring.

If you still have issues try connecting controllers one by one and check the Device Manager each time.

Craig
Reply
#3
Thankyou for the quick response will try both tomorrow.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)