20-03-2018, 08:12 PM
Hello again Craig,
I have, as far as i know, followed your instructions to the letter. I am obviously missing something.
I have configured the ETH08 controller as you suggested and in the control section of the Ethernet device manager, everything is exactly as it should be. I can control all six outputs and each and every pixel.
When using the device manager I notice that the green LED flashes at a fast rate as it receives the data. when running my show, on the other hand, the same LED is just flashing at the 'normal' connected rate. the light control button is set to 'ON' and the serial comms work as expected.
I have attached 3 screenshots to show how things stand at the moment. Screenshot 6 was just a test one.
I have, as far as i know, followed your instructions to the letter. I am obviously missing something.
I have configured the ETH08 controller as you suggested and in the control section of the Ethernet device manager, everything is exactly as it should be. I can control all six outputs and each and every pixel.
When using the device manager I notice that the green LED flashes at a fast rate as it receives the data. when running my show, on the other hand, the same LED is just flashing at the 'normal' connected rate. the light control button is set to 'ON' and the serial comms work as expected.
I have attached 3 screenshots to show how things stand at the moment. Screenshot 6 was just a test one.