01-12-2017, 10:07 AM
Hi All, I have just started putting together my first show and have an issue I cannot resolve looking for some advice.
when I create my layout within showbuilder I group items in the layout wizard.
at the moment I have two 8 channel dc controllers, 8 LED strings and 8 led figures.
when I group them I make sure that the channel number is correct for each light
id 1 has all the figures, one tree, three penguins, santa, polar bear, two snowmen
id2 has the leds, two blue, two green, two red and two white.
when I create my layout I group them in that order and validate before uploading.
I've chosen the free shows to test and the resultant show builds downloads and runs.
the problem I have is the grouping is all wrong
the penguin group become two penguins and a polar bear
the snowmen group becomes one snowman and a Santa
the Led's are not paired two greens are a green and white
I check each lights card id and channel are correct when creating the layout
any advice in resolving this within the programming, I know I can swap around the cabling but was looking for a better resolution that would be a pain when I get to connect all four dc controllers
thanks for any help
when I create my layout within showbuilder I group items in the layout wizard.
at the moment I have two 8 channel dc controllers, 8 LED strings and 8 led figures.
when I group them I make sure that the channel number is correct for each light
id 1 has all the figures, one tree, three penguins, santa, polar bear, two snowmen
id2 has the leds, two blue, two green, two red and two white.
when I create my layout I group them in that order and validate before uploading.
I've chosen the free shows to test and the resultant show builds downloads and runs.
the problem I have is the grouping is all wrong
the penguin group become two penguins and a polar bear
the snowmen group becomes one snowman and a Santa
the Led's are not paired two greens are a green and white
I check each lights card id and channel are correct when creating the layout
any advice in resolving this within the programming, I know I can swap around the cabling but was looking for a better resolution that would be a pain when I get to connect all four dc controllers
thanks for any help