26-01-2022, 01:52 PM
Hi Folks
I was mounting and setting up some controllers and have inadvertently given one of them an ID that I had already issued to the last controller I added. Now only 1 of them shows up when I check the RS485 tab or click to browse. I have a solid led but the controller is invisible to all intents and purposes. I assume I need to default this controller back to ID1 but no idea how to do this?
Thanks
I was mounting and setting up some controllers and have inadvertently given one of them an ID that I had already issued to the last controller I added. Now only 1 of them shows up when I check the RS485 tab or click to browse. I have a solid led but the controller is invisible to all intents and purposes. I assume I need to default this controller back to ID1 but no idea how to do this?
Thanks