Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
show player stops , but lights stay on steady
(21-12-2020, 12:57 AM)cymglo Wrote:
(21-12-2020, 12:00 AM)grigg Wrote:
(20-12-2020, 11:54 PM)cymglo Wrote: I've got this too... Wherever the show is at the schedule end time it will stop dead. I get round this by going into the ethernet device manager and start/stop the test pattern.
 Only seem to have this issue with the ethernet controller, previous years with the DC controllers it would finish the show that was running at the end time.

what mode do you have set in the scheduler? interactive,interval,manual or continuous?

Got it set to continuous - 5 shows total of 09:10

try setting it to interval mode with 5 mins between each show.

might be worth creating a "idle show to go in between each show, this can be a show where you set all lights to in etc 

let me know how you get on 

We have been trying to recreate this issue but the shows always play to the end in our tests.

As a work around you could try creating a blank show and schedule it to run once a few minutes after the finish time of the main schedule. This would then force all the lights off.

Forum Jump:

Users browsing this thread: 1 Guest(s)