15-08-2020, 07:45 PM
Yes you can wire a relay to the outputs of the DC Controllers. You may need to add a diode to prevent fly-back to protect the controller. You may also need a resistor depending on the relay.
Craig
Craig
Thread Rating:
|
Using 3 channel controller to run relays.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Using 3 channel controller to run relays. - by Pauls - 14-08-2020, 09:16 AM
RE: Using 3 channel controller to run relays. - by Craig - 15-08-2020, 07:45 PM
RE: Using 3 channel controller to run relays. - by Pauls - 15-08-2020, 08:32 PM
RE: Using 3 channel controller to run relays. - by Craig - 15-08-2020, 09:44 PM
RE: Using 3 channel controller to run relays. - by Pauls - 16-08-2020, 12:53 PM
RE: Using 3 channel controller to run relays. - by Pauls - 19-08-2020, 04:38 PM
RE: Using 3 channel controller to run relays. - by Craig - 19-08-2020, 07:08 PM
|
Users browsing this thread: 1 Guest(s)