07-12-2017, 11:17 AM
Be sure that the Pixels per channel is set to 1 if you want to control individual pixels.
Also
-Keep the lead wire as short as possible, ideally no more that 1 or 2 meters. (you can run have longer runs ; but longer wire is more prone to voltage drop and interference etc)
-If connecting sets it is critical to inject power at the start of each set. Inject power directly from the power supply. Often best to inject power to the end of the string also.
-The controller can sometimes pick up static from some types of surface. Try raising the controller off the surface slightly or placing on a different surface.
Craig.
Also
-Keep the lead wire as short as possible, ideally no more that 1 or 2 meters. (you can run have longer runs ; but longer wire is more prone to voltage drop and interference etc)
-If connecting sets it is critical to inject power at the start of each set. Inject power directly from the power supply. Often best to inject power to the end of the string also.
-The controller can sometimes pick up static from some types of surface. Try raising the controller off the surface slightly or placing on a different surface.
Craig.