27-11-2017, 01:53 PM
I did as you said and formatted the SD card, but I am still having issues.
For testing I have the RS485 connected from the computer to controller no.2, from there the data cable goes to the SD controller (device no,4) and then from there the data cable goes to the show selector (device no,5).
When I go to device manager and search for connected devices it only show no,5 the show selector at the end of the network, if I then remove and replace the SD card or disconnect the power to it and then reconnect, doing a search for devices shows 2, 4, and 5. Leave it a few seconds or use show designer to check if pixels are working and again nothing, so replace SD card and the pixels work fine in show designer.
If I take the data cable connection from the SD card controller the other controllers show up in device manager ok.
Any suggestions?
Phil
For testing I have the RS485 connected from the computer to controller no.2, from there the data cable goes to the SD controller (device no,4) and then from there the data cable goes to the show selector (device no,5).
When I go to device manager and search for connected devices it only show no,5 the show selector at the end of the network, if I then remove and replace the SD card or disconnect the power to it and then reconnect, doing a search for devices shows 2, 4, and 5. Leave it a few seconds or use show designer to check if pixels are working and again nothing, so replace SD card and the pixels work fine in show designer.
If I take the data cable connection from the SD card controller the other controllers show up in device manager ok.
Any suggestions?
Phil