28-12-2016, 05:35 PM
For 2811,2812 or 2801 you need to ensure you have single output SD card controller. Earlier version were sold as single output or 4 outputs, recent versions are configurable by PCB jumpers and are normally dispatched preset for single output.
If you are configuring for stand-alone use, using the supplied sequences, it is important that the controller id is set to 1, as this is what the pre-programmed sequences are set for. If the SD card controller and strip were purchased from us together, we usually configure the SD card controller for you. When the stand-alone sequences are playing the LED with flash quickly and pressing the button will change between sequences.
If you are configuring for stand-alone use, using the supplied sequences, it is important that the controller id is set to 1, as this is what the pre-programmed sequences are set for. If the SD card controller and strip were purchased from us together, we usually configure the SD card controller for you. When the stand-alone sequences are playing the LED with flash quickly and pressing the button will change between sequences.