Hi everyone,
I'm having a bit of a problem getting the SD card controller to work.
I have hooked up a 1 metre 2812 strip and it doesnt do anything other than blink all the led's at powerup. I have used the utility on the SD card and set it to Stand-alone, 60 channels, 1 output and the correct type.
Double checked the connections at the controller, + pin to 5V on strip, - pin to GND on strip, DAT to DIN on strip and CLK not connected.
In the absence of another controller I had an Arduino sitting around so I've hooked that up to the strip and ran a test pattern with no problems so the strip is working fine.
Is there anything I might be doing wrong or something I've missed?
Cheers
Tom
I'm having a bit of a problem getting the SD card controller to work.
I have hooked up a 1 metre 2812 strip and it doesnt do anything other than blink all the led's at powerup. I have used the utility on the SD card and set it to Stand-alone, 60 channels, 1 output and the correct type.
Double checked the connections at the controller, + pin to 5V on strip, - pin to GND on strip, DAT to DIN on strip and CLK not connected.
In the absence of another controller I had an Arduino sitting around so I've hooked that up to the strip and ran a test pattern with no problems so the strip is working fine.
Is there anything I might be doing wrong or something I've missed?
Cheers
Tom