13-11-2019, 11:41 PM
(13-11-2019, 11:06 PM)jack grigg Wrote:(13-11-2019, 07:52 PM)Nathanm114 Wrote:(13-11-2019, 06:29 PM)jack grigg Wrote:(13-11-2019, 07:58 AM)Nathanm114 Wrote: Hello,hi Nathan have you tried connecting each controller for each set of elements directly to the pc i would recommend trying this to rule out a problem somewhere else in your network also have you got the latest software v3.03.03 in this version it checks your configuration against the controllers configuration works for both ethernet and rs485 networks king regards jack
I test in device manager and it’s also the same when I do run the show in the designer.
I set the eyes to 100% in the show.
All the controllers I am using are DC08’s.
Kind Regards
Nathan
Hello,
Have tried this with no luck plus software is on the latest version.
When I test I prefer to do it one at a time.
Kind Regards
Nathan
hi nathan have you tried unplugging everything else from the controller and leaving just the eyes plugged in i had a few controllers last year that when all the outputs are in use it made the output before that go a little dimmer (e.g i had a white string on output 1 and a blue string on output 2 put when i plugged a string into output 3 both the previous outputs went dimmer) also what power supply are you using for the controller itself kind regards jack
Hello,
I haven’t tried that so I will look into that but in regards to power supply I bought it from syncrolight them self’s. Just read an update on the product page that has been added since the purchase of the power supply.
https://syncrolight.co.uk/ProductDetails...2A-SW.aspx
Kind Regards
Nathan