SL-4000E lost network.... - Printable Version +- Syncrolight Forum (https://www.syncrolight.co.uk/forum) +-- Forum: Light Shows (https://www.syncrolight.co.uk/forum/forumdisplay.php?fid=1) +--- Forum: General (https://www.syncrolight.co.uk/forum/forumdisplay.php?fid=2) +--- Thread: SL-4000E lost network.... (/showthread.php?tid=239) |
SL-4000E lost network.... - philspectrum - 03-12-2021 Re: SL-4000E stopped working but still lights up. I have been playing with my SL-4000E and a single pixel string setup via eithernet. (Meanwhile, - have been building my showpiece) I setup using the instructions, - obtained IP address etc - all good. THEN, Yesterday .... somthing changed........ everything stopped working, - thou red lights are on for Power & SD The NET light on the controller blinks once when switced on, - then remains blank, - and does not show up in Device manager. I have tried to reconnect, Force Address etc, - and although DM gives a forced address, nothing shows up, - and the NET light stays fully off. The network plug on the back of the controller constantly blinks green, and has a orange light on all the time. My switch shows a cable connected to the plug used. I have tried different cables The controller does not auto play from the SD card .... have I got a brick? The last think I did while it was working was click to 'manual control' so I could individually control my test string of pixels from show creator. Hope you can advise, I am dying to indoor test my creation, - so I can put up outside soon. many thanks Phil |