+- Syncrolight Forum (https://www.syncrolight.co.uk/forum)
+-- Forum: Light Shows (https://www.syncrolight.co.uk/forum/forumdisplay.php?fid=1)
+--- Forum: General (https://www.syncrolight.co.uk/forum/forumdisplay.php?fid=2)
+--- Thread: Pixel Layout (/showthread.php?tid=125)
Pixel Layout - steve1200 - 09-12-2018
I am trying to setup a pixel wall on my display I have 400 pixels
organised as follows
Output one is a 50 pixel post
Output two is a 50 pixel post
Output three is lines one and two of the wall 100 pixels
output Four is third line 50 pixels
Output Five is lines four 5 and six
all of the pixels are working and the reason they are wired like this is I am building as I go along.
I am trying to create a wall so I can make images, sweep colours and text.
I have created a visualisation file for just the pixels.
the problem I have is the wall is treated as a long string - a sweep goes from pixel 1 to 300 in a single line.
anyone have any idea what I am doing wrong ?
RE: Pixel Layout - Jane - 09-12-2018
You need to create your wall as a pixel grid. Have you looked at the samples as there is a pixel grid sample in there.
Jane
Syncrolight
RE: Pixel Layout - steve1200 - 09-12-2018
do all of the pixels need to be on one channel of the controller ?
I have them connected over three channels - is that where I am going wrong ?
RE: Pixel Layout - Jane - 09-12-2018
Yes you can split the pixels over multiple outputs even over several controllers.
Jane
Syncrolight