05-12-2017, 07:28 PM
Hi I am trying to setup my first set of pixel lights on an Ethernet controller. I have connected I 2801 pixel string to channel 1
I can get them to work and the colours are correct however if I try to use a single pixel/LED I get the following 5 or six pixels lighting too.
if I light two or three pixels then the following ones light too.
I have configured the card to the correct settings
any pointers to where I should look for the problem -
should I power the strings from the power supply to the red and black wires ?
any help much appreciated
steve
I can get them to work and the colours are correct however if I try to use a single pixel/LED I get the following 5 or six pixels lighting too.
if I light two or three pixels then the following ones light too.
I have configured the card to the correct settings
any pointers to where I should look for the problem -
should I power the strings from the power supply to the red and black wires ?
any help much appreciated
steve